Baumuller BUM64A, Руководство пользователя

Страница: 46 / 120

Connections
Manual Single Power Unit BUM64S/A/F
Document no.: 5.01056.03
Baumüller Nürnberg Electronic GmbH & Co. KG
46
of 118
6.5
1)
Position, see Z figure 10 – on page 45.
*: Voltages that may appear at the terminals
**: Currents that may flow across the terminals
2)
choose the connection cross-section from the actual standards (e.g. DIN VDE 0100-430) depending on your application.
3)
for cooling variants S and A only. The 2-pole terminals 12/13 named N and L for the 230 V-connection of the ventilator are situated at
the bottom on the right side near the power terminals (see
Z figure 22 – on page 59).
6.5.2 Control connections
.
terminal pos.
1)
description U
interval
* I
interval
** A
2)
1U2 1 U phase motor terminal 0 V (Û)
to
830 V (Û)
0 A (I
AC
)
to
235 A (I
AC
)
depend-
ing on the
cable lugs
used
1V2 2 V phase motor terminal
1W2 3 W phase motor terminal
S 4 earth connection
1U1 5 L1 phase mains connection 360 V (U
AC
)
to
528 V (U
AC
)
0 A (I
AC
)
to
230 A (I
AC
)
1V1 6 L2 phase mains connection
1W1 7 L3 phase mains connection
S 8 earth connection
Ba- 9 Ballast resistor connection
Ba- is connected to the collec-
tor of the breaking switch
Ba+ is 1C1 between
Ba+ and Ba-
0 to 830 V (U
DC
)
0 A (Î)
to
130 A (Î)
1C1 10 + DC link connection between
1C1 and 1D1
0 to 830 V (U
DC
)
0 A (I
AC
)
to
410 A (I
AC
) 1D1 11
- DC link connection
L 12 ventilator connection
3)
207 V (U
DC
)
to
243 V (U
DC
)
0 A (I
AC
)
to
1 A (I
AC
) N 13
WARNING
The following may occur , if you do not observe this warning information:
m serious personal injury m death
The hazard is: Electricity.
Do not overload the control connections. The permissible maximum current of 10 A per ter-
minal must not be exceeded.
Make sure, that all applied control voltages meet the PELV or SELV requirements.