Bartscher E500 LPR, Инструкция по эксплуатации, Страница: 24 / 32

- 44 -
6.1.2 Starting the device
Before switching the device on make sure that the following conditions are met:
-
Water shut-off valve is open.
-
Water supply is ensured.
-
All filters are installed in the intended places.
- Overflow is in the right place.
- Device door is closed.
To switch the device on, turn the control knob from “ 0“
(E)
position to “ F“
position.
(Fig. 9, page 43). ON indicator light (orange) comes one.
6.1.3 Filling and heating process
Filling process begins after starting the device. First the rinsing boiler is filled in, and
then the wash-tank. Filling process may take up to a few minutes. As soon as the wash-
tank is filled in, the heating process of both the boiler and the wash-tank starts.
Although it would be now possible to start the washing process, the manufacturer
does not recommend this, because the water inside the device has not reached the
optimum temperature yet. As soon as the device reaches the optimum temperature
for appropriate dish washing, the user is informed about it by standby indicator light
coming on (C).
The device must reach the temperature of 85 °C in the rinsing boiler and 60 °C in the
wash-tank. It is recommended that the water in the device should be changed every
40/50 washing cycles or twice a day.
NOTE!
To start the filling process, the device door must be fully closed.
Due to safety reasons, the device cannot be filled in with open door.
The device is equipped with a safety thermostat inside the boiler and another safety
thermostat inside the wash-tank. In case of the failure of any of the main thermostats,
the heating process is stopped.