Bartec PSB 27-1680, Инструкция по установке и эксплуатации

Страница: 5 / 12

EN 5/12
Table
4
Protection device: 16 A, 20 A, 32 A
Frequency: 50 oder 60 Hz
Construction week/year: 15/2009 (for example)
5
3
6
1
impressed voltage
Reservation
Technical data subject to change without notice. Changes, errors and misprints may not be used as a basis for any claim for damages.
Typ heat trace Supply Supply T-class Temp.
voltage voltage
07-5801-110 * 120 V T5 T95 °C
07-5801-113 * 120 V T5 T95 °C
07-5801-115 * 120 V T5 T95 °C
07-5801-126 * 120 V T5 T95 °C
07-5801-133 * 120 V T5 T95 °C
07-5801-210 * 254 V T6 T80 °C
07-5801-213 * 254 V T6 T80 °C
07-5801-215 * 254 V T6 T80 °C
07-5801-226 * 254 V T5 T95 °C
07-5801-233 * 254 V T5 T95 °C
8. Type label heating system
The type label is to be filled in manually on the basis of the table and
points 1-6. The blanks in the heating system’s type number must be filled
on the basis of the components used. A water-proof and lightfast marker
must be used (e.g.: Staedtler
Lumocolor permanent special marker or
BARTEC no.: 02-7140-0001).
The serial no.: and the TAG no. can be filled in by the person setting up
the heating-circuit.
A practical example of a filled-in type label is given further on.
The type label must be stuck onto the lid of the junction box. The surface
must be cleaned first before the glue is applied. Care must be taken that
the sticker is put on carefully. It may not jut out over the correct area and
it may not have any air bubbles.
Practical example:
The following components were used:
PSB 120 V 26 W; Cold-applied connection technology and BARTEC
polyester junction box.
It was filled in according to the grey-shaded line in the table.
2
1
2
3
4
5
6