Bartec PSB 27-1680, Инструкция по установке и эксплуатации

Страница: 9 / 12

EN 9/12
Make an incision into the edges of the heating element.
Push the green/yellow heat shrinkable tubing
e
(150 mm) onto
the twisted metal braid covering. Make an incision into the
insulating jacket at a point 115 mm from the beginning of the
heating tape and remove that amount.
5
Twist the metal braid covering.
4
8
Pull the strands out and twist them. Remove the remaining
heating element. (Fig. 7 and 8)
7
Reservation
Technical data subject to change without notice. Changes, errors and misprints may not be used as a basis for any claim for damages.
Cut out a triangle (5 mm) between the strands. Put some silicone
adhesive
h
onto the exposed heating element, the insulating
jacket and into the silicone hose. Push the silicone hose d over
the exposed wire and the insulating jacket. Push the sealing
b
directly up to the silicone hose.
9
150
115
5
13
0
6