Bartec BCS3600ex Series, Руководство пользователя

Страница: 152 / 174

Faults – causes and
remedies BCS3600
ex
series
Hand-held scanner and accessories
144/164
Subject to technical changes.
April 2022 / Revision C
Hand-held scanner emits
beeps at regular intervals Wrong interface cable is being
used 1. Check the interface cable.
2. If the wrong interface cable is
being used: connect the correct
interface cable.
Interface cable or mains cable is
loose 1. Check cable connections.
2. Connect loosely connected cables
correctly.
Only for BCS3678
ex
-IS
Hand-heldheld scanner does
not respond / hangs up
Battery is in the sleep mode.
If the battery or the device are
not in operation, the battery
switches to sleep mode after a
few seconds.
The full voltage can then no
longer be measured at the
battery contacts.
Depending on the capacity
between 3.4 V and 3.6 V. The "sleep mode" is cancelled as soon
as the trigger key or another action is
executed on the BCS3678
ex
.
The battery is in shutdown
mode.
If the battery is deep-charged or
is unused for a longer period
(longer than 3 months), the
battery switches to shutdown
mode.
A battery in shutdown mode
shows 0 V at the battery
contacts. The battery can be switched out of the
shutdown mode in the following way:

Insert the battery for at least 5
seconds into an associated 4-slot
battery charging station with 12 V
power supply.

Insert the BCS3678ex with
inserted battery for at least 5
seconds into an associated base
station with a 12 V power supply.
The battery is reactivated in this way.
A voltage of at least 2.6 V can be
measured.at the battery contacts.
It is recommended that the battery is
then fully charged.