Operating Manual for 3D Printer BT1.2
24
5.
Printing
5.1
Starting printing - programme (*.gcode)
The device is only able to run (read) programmes (files) in the "gcode" format, generated
by special software (called "slicer"). This software is able to generate a programme for
controlling the device from the part model that we want to print. The generated .gcode
file is uploaded to the SD card or USB flash drive and run on the device. The file system
on the SD or USB flash drive must be FAT32. This USB port does not support mass
storage hard drives.
The programme can also be run after connecting to a computer via the USB port on the
back of the control board cabinet. To connect to a computer, the device baud rate must
be set to 25000 baud (bit/s).
LCD TFT32
SD card port
ventilator FAN2speed
indicator
required pad temperature
required nozzle temperature
current nozzle
position
actual pad temperature
USB flash disk port
To select the input media (USB or SD card), press:
SET -> FILE -> SD
or
USB
