Operating Manual for 3D Printer BT1.2
10
3.6
Operator Safety Instructions
(the device operator must follow these instructions)
THE EQUIPMENT'S ELECTRICAL PARTS MUST NOT BE RINSED WITH WATER!
➢
Safety elements must always be kept in perfect condition
➢
Keep the device safety markings legible
➢
Be sure to follow this manual's safety instructions
➢
Read these operating instructions, including other instructions for any sub-equipment, carefully before
using the device in any way.
➢
If the device begins to shake strongly, shows increased noise or other abnormalities during operation,
turn it off and have it checked immediately.
➢
Do not start the device without covers
➢
damaged equipment must never be used
➢
the equipment must only be used for the purposes for which it was designed
➢
only work in good lighting conditions
➢
Before starting work, the operator must perform a visual inspection on the equipment's moving parts
for signs of excessive wear or damage.
➢
This device cannot be used with excessively worn or damaged parts
➢
Only carry out device maintenance and cleaning when the power supply is disconnected
➢
This device may only be operated by people over 18 years of age, who are mentally and physically fit,
well acquainted with its properties and familiar with the relevant regulations for its operation.
Younger people may only operate the device under the supervision.
➢
It is forbidden to operate the device under the influence of alcohol, drugs or other narcotics
➢
All device maintenance and repairs must only be carried out with the device stopped and properly
secured
➢
The device is intended for indoor use only (premises)
