Baroness GM2810A, Руководство по эксплуатации для владельца, Страница: 76 / 155

<Parked regeneration>
These are the conditions for activating
parked regeneration.
The parking brake is applied.
The traveling pedal is in neutral.
The throttle opening is 0% (idling).
The DPF auto regeneration inhibit
switch is set to the "Auto regeneration
mode". (Auto regeneration inhibit icon
disappears.)
The blinking regeneration icon appears.
When the DPF auto regeneration inhibit
switch set to the "Auto regeneration
mode":
1
65 C 55 %
2400 RPM 100 %
% SOOT ENG RPM
FUEL LEVEL COOL TEMP
xlfvcz-004
Level 2_003
1 Regeneration icon
When the DPF auto regeneration inhibit
switch set to the "Auto regeneration inhibit
mode":
65 C 40 %
2400 RPM 100 %
% SOOT ENG RPM
FUEL LEVEL COOL TEMP
1
27gtuu-008
Level 2_004
1 Regeneration icon
Stop traveling and cutting work.
Park this machine in a safe location.
Apply the parking brake.
Set the throttle opening to 0% (idling).
･
1.
2.
3.
4.
1.
2.
3.
4.
5.
Press the DPF parked regeneration
switch.
Parked regeneration starts and the
regeneration icon changes from blinking to
lighting.
When the regeneration completed, the
regeneration icon disappears.
Level 3
Danger Danger
Since it will become extremely hot around the
exhaust outlet during DPF regeneration, do
not perform the regeneration in a location
where fires may occur.
Important
When the system enters the level where DPF
regeneration is required, perform the
regeneration immediately.
Interrupting the regeneration or ignoring the
warning and continuing traveling or cutting
work may cause the engine and DPF to
malfunction.
Important
If ignoring the parked regeneration
requirement and continuing traveling or cutting
work in PM accumulation "Level 3", PM
accumulation level enters "Level 4".
If still continuing traveling or cutting work, you
will not be able to operate this machine for
regeneration.
Important
Automatic regeneration can not be activated
in PM accumulation "Level 3".
Perform parked regeneration immediately.
You can not continue to use this machine
for traveling and cutting work during DPF
regeneration.
You can operate this machine to perform
the regeneration. (The fault diagnostic tool
is not required.)
6.
7.
￭
･
･
GM2810A
Description of Functions
Page 4-40
Engine