Baroness GM2810A, Руководство по эксплуатации для владельца, Страница: 117 / 155

Wind new sealing tape on the drain plug,
and then attach it to the hydraulic tank.
1
2
k9yr5z-002
Change of Hydraulic Oil_001
1 Hydraulic tank
2 Drain plug
Remove the left tank cover.
Open the tank cap, and then pour new oil
from the fill port until the oil level reaches the
middle of the oil gauge on the hydraulic tank.
The hydraulic tank capacity is approximately
44.0 dm
3
(44.0 L).
1
2
dmhzyz-013
Change of Hydraulic Oil_002
1 Tank cap
2 Oil gauge
Tighten the tank cap securely.
Start the engine, raise and lower the mower
decks, and turn the steering wheel left and
right.
Move forward and reverse repeatedly
several times.
Raise the mower decks and maintain that
position on a level surface, and then check
to see if the oil level is at the middle of the oil
gauge. If necessary, supply oil.
Check underneath the machine for oil
leakage.
Attach the left tank cover.
[4]
2.
3.
4.
5.
6.
7.
8.
Change of Hydraulic Oil Filter
Change of Hydraulic Oil Line Filter
Caution
Be careful with hot oil, which could cause
burns if it contacts your skin.
Important
When replacing the hydraulic oil filter, be sure
to drain the oil into a container and discard it
in accordance with local laws and regulations.
Important
If the hydraulic oil emulsifies or if it becomes
even slightly less transparent, change the oil
immediately.
Important
Use Shell Tellus S2M46 (or equivalent) as
hydraulic oil.
On a level surface, lower the mower decks,
and then stop the engine.
Remove the filter protection plate.
1
2
3
ycfdh6-024
Change of Hydraulic Oil Line Filter_001
1 Filter cartridge
2 Filter protection plate
3 Bolt
Loosen the old filter cartridge by hand and
remove it.
Lightly coat the packing of the new filter
cartridge with hydraulic oil, and then install
the cartridge.
1.
2.
3.
4.
Maintenance
GM2810A
Maintenance
Page 6-17
Adjustment and Replacement