9.
During normal Recirculation mode, a purity and
temperature reading will be printed once every
12 minutes.
Printer Setup
Power Switch
Located on the front of the printer (AY1137X1), this switch
turns power to the printer ON and OFF. (See Figure A.)
The green POWER light will illuminate when the printer is
ON.
Paper Feed Button
Press this button once to advance the tape one line, or
hold the button down to advance paper continuously.
When the paper roll nears the end, the red PAPER OUT
light will illuminate.
If the red ERROR light illuminates, the printer is off line.
This could be a result of the print head being too hot, in
which case the printer will resume printing once it cools
down; or—the paper may be jammed in the printer. Turn
the printer OFF before checking for jammed paper.
Remove the paper jam and turn the printer back ON. If
the printer still will not print, unplug it and refer servicing
to qualified personnel.
Installing the Paper Roll
When the red PAPER OUT light illuminates, it is time to
replace the paper roll. Replace the paper roll (AY669X4)
as follows:
1. Turn the printer ON and open the chamber cover.
2.
Make sure the edge of the paper roll is straight.
3.
Insert the paper roll into the printer. (See Figure
C.)
4.
Insert the paper straight into the paper slot (see
Figure D). The paper will feed automatically.
5.
Tear off a strip of paper and close the cover.
(The red PAPER OUT light will be OFF if paper
roll installation is successful.)
C
OMPUTER
/P
RINTER
S
ETUP
37
Note
A colored stripe along the edge of the
paper indicates that you are approach-
ing the end of the tape. When the
stripe appears, approximately 23 inch-
es ( 58.4 cm) of paper remains,
enough for 1-2 days. Replace the tape
before it is completely exhausted to
ensure a complete record of your
analyses.
Figure C: Inserting the Paper Roll
Figure D: Inserting the Paper Into the Paper Slot
