Ultrafilter Installation
Remove the ultrafilter from its protective bag. Install the
ultrafilter as follows:
1.
Open the front (right side) door and the right
side door.
2.
Remove restraints (twist tie) from the three
tubes.
3.
Locate the metal bracket and separate the
Velcro
®
strap.
4.
Remove the cap on the top side port of the
ultrafilter (make sure the bottom cap on the bot-
tom side port is secure).
5.
Align the ultrafilter with the metal bracket (Side
ports should face the back of the unit) and push
the bottom fitting tightly into the bottom connec-
tor. Insert side ports into the metal bracket.
6.
Push the top fitting of the ultrafilter into the top
connector, making sure the connection is tight.
7.
Secure the ultrafilter with the velcro strap.
8.
Connect tubing with luer fitting to the top side
port.
9.
Close and latch right side door and front (right
side) door.
I
NSTALLATION
Ultrafilter Installation
Note
Do not install the ultrafilter until the
NANOpure DIamond UF is ready for
use. If the unit sits for longer than 72
hours without use, it will become con-
taminated and may affect product
water quality.
10
Ultrafilter with fittings
Bottom side port with cap
Top side port with cap
removed
Metal bracket
Velcro strap
Ultrafilter Connections (Right side view)
Bottom connector
Top connector
Note
The ultrafilter must be installed before
the 0.2 micron filter. Please refer to
“0.2 Micron Filter Replacement” under
“Maintenance and Servicing” for
instructions on how to replace the 0.2
micron filter.
Top side port
tubing with
luer fitting
® Velcro is a registered Trademark of Velcro Industries B.V.
