Barko 830B, Руководство по обслуживанию

Страница: 200 / 218

65-18 ®
SERVICE- H1B HYD MOTOR
(continued...)
1
2
3. MINOR REPAIRS
Fig-7
3.1 Shaft Seal (Fig-7)
1.
2. Use a slide-hammer style puller to remove
seal (2). Be careful not to damage the shaft
or seal bore when removing. Discard seal.
Using snap ring pliers, remove retaining ring
(1).
3.1.1 Removal
Inspect retaining ring for wear or damage.
Replace if necessary. Inspect shaft for wear or
groove at seal area.
3.1.2 Inspection
3.1.1 Assembly
1.
4.
3.
2.
5.
Lubricate inside diameter of new seal.
Cover the shaft splines with shaft cover or
packing tape to avoid damaging the seal
during installation.
Using seal installation tool, press seal into
housing bore.
Using a snap ring pliers, install retaining ring
(G0030).
Use seal installation tool to press seal and
retaining ring into housing until retaining ring
snaps into its groove.
If not using seal installation tool: Do not press seal
beyond snap-ring groove. Stop pressing just when
you have room to install the retaining ring into the
bore. Pressing the seal and snap-ring together
ensures proper installation depth. Using the seal
installation tool prevents pressing the seal too deeply.
06/05/2019
Updated
SERVICE