Barco TransForm A, Руководство по обслуживанию

Страница: 25 / 61

Barco – TransForm A – DOC-3358-2 – service manual – Revision 06 – March 2007
_________________________________________________________________________
2-14
•
Inside of the housing there is a transportation lock, which must also be removed to be able to insert expan-
sion cards. Loosen the fixation screws [1], [2] and [3] and take out the plate, please refer to the figure be-
low.
1 2 3
1, 2, 3 fixation screw for transportation lock
Figure 2-18
Transportation lock of the O
MNI
B
US
A18
•
Before closing the housing the transportation lock must be readjusted. Therefore first insert the plate, then
turn in the screws but do not tighten them. Push the plate as far towards the cards as possible. Just then
tighten the screws.
If you have removed the top cover and elastic hold-down of the OmniBus A18 in order to
add boards, be sure to replace both parts before powering up again!
2.3.5 The expansion slots of the OmniBus A18
On the backplane of the O
MNI
B
US
A18 there are 18 PCI slots to insert expansion cards from Barco. The PCI slots of
the O
MNI
B
US
A18 are meant to insert UGX or AGX G
RAPHIC
C
ARDS
, O
MNI
S
CALERS
, Q
UAD
A
NALOG
V
IDEO
C
ARDS
, S
TREAMING
V
IDEO
C
ARDS
, D
UAL
RGB I
NPUT
C
ARDS
and Q
UAD
SDI V
IDEO
C
ARD
s.
link
slot PCI 12 PCI 17 PCI 11 PCI 16 PCI 10 PCI 15 PCI 9 PCI 14 PCI 8 PCI 13 PCI 7 PCI 6 PCI 5 PCI 4 PCI 3 PCI 2 PCI 1 PCI 0 CPU
board
Figure 2-19
PCI slots of the O
MNI
B
US
A18
Barco recommends certain expansion cards for the use in the OmniBus A18! Using other
cards might cause damage to the OmniBus A18 or might damage the cards themselves! The
described graphic and video capabilities of TransForm A
are only available with the original
expansion cards from Barco.