Barco – TransForm A – DOC-3358-2 – service manual – Revision 06 – March 2007
_________________________________________________________________________
2-19
2.4.5
Opening the top cover of the Extender
Before opening the case, switch off the Extender with the power button on the front!
Disconnect all power plugs! Remove all cables!
The boards of TransForm A contain CMOS components. Do not touch the components, they
could be destroyed!
Loosen the housing screws [1] and [2] shown in
Figure 2-23 Side view of Extender
on both sides of the case. For
these screws as well as for the screws inside of the E
XTENDER
you need a size 2 Phillips screwdriver. Some screws
inside the E
XTENDER
can be loosen with a 5.5 spanner as well.
Figure 2-25
Screws of the case of the E
XTENDER
Now you can easily remove the top cover.
If you have removed the top cover of the Extender in order to add boards, be sure to
replace the cover before powering up again!
Inside of the housing there is a transportation lock, which must also be removed to be able to insert expansion
cards. Loosen the fixation screws [1] and [2] and take out the plate, please refer to the figure below.
Before closing the housing the transportation lock must be readjusted. Therefore first insert the plate, then turn
in the screws but do not tighten them. Push the plate as far towards the cards as possible. Just then tighten the
screws.
1
2
1, 2
fixation screw for transportation lock
Figure 2-26
Transportation lock of the E
XTENDER
