Location and Function of Controls
4-3
5975187 BARCOGRAPHICS 2100 200597
Terminology
Back light key
: when activated, all keys will light up and
are visible in the dark.
ADJ.
: ADJUST key, to enter the adjustment mode or for
quick exit in the adjustment mode.
A
ddress key (recessed key), to enter the address of the
projector (between 0 and 9). Press the recessed address
key with a pencil, followed by pressing one digit button
between 0 and 9.
STBY
: stand by button
- to start projection when
the
power switch is switched on.
- to switch off the projector without switching off the
power switch.
PAUSE
: to stop projection for a short time, press 'PAUSE'.
The image disappears but full power is retained for imme-
diate restarting.
MUTE :
to interrupt the sound reproduction.
Digit buttons
: direct input selection.
Sound controls :
use these buttons to obtain the desired
sound reproduction (see also 'Controlling').
Picture controls
: use these buttons to obtain the desired
picture analog level (see also 'Controlling').
PHASE
: used to remove instability of the image.
10
1
2
3
4
5
6
7
8
9
TEXT
: when adjusting one of the image, e.g. controls
during a meeting, the displayed bar scale can be removed
by pressing 'TEXT' key first. To re-display the bar scale on
the screen, press 'TEXT' key again.
FREEZE
: press to freeze the projected image.
ENTER
: to start up the adjustment mode or to confirm an
adjustment or selection in the adjustment mode.
EXIT
: to leave the adjustment mode or to scroll upwards
when in the adjustment mode.
Control disk
(on RCU) or
'+' and '-' keys
(cursor keys):
to make menu selections when in the adjustment mode.
The control disk can move up, down, to the right or to the
left.
Comparision between control disk movement and the use
of the cursor keys on the local keypad :
RCU
=
local keypad
control disk up
=
'+' key up
control disk down =
'-' key down
control disk to the right
=
'+' key right
control disk to the left
=
'-' key left
Use the
'+' and '-' keys
(cursor keys) : to increase or
decrease the analog level of the image controls when they
are first selected.
RC operating indication
: lights up when a button on the
remote control is pressed. (This is a visual indicator to check
the operation of the remote control)
11
12
13
14
15
16
