Barco IQ-Graphics 300, Руководство пользователя

Страница: 36 / 94

5-6
Getting Started
5976367 BARCO IQ-G300 24092001
Projector address
Why a projector address ?
As more than one projector can be installed in a room, each projector should be individualy addressable wiht an RCU or computer.
Therefore, an individual address should be set for each projector.
Set up an Individual Projector Address.
The set up of a projector address can be done via the Menu.
See "Projector address" in chapter ''Installation".
How to control the projector or projectors.
Every projector requires an individual address between 0 and 255 which can be set in the "Installation" menu.
When the address is set, the projector can be controlled now via:
- RCU for addresses between 0 and 9.
- computer, e.g. IBM PC (or compatible), Apple MAC, etc. for addresses between 1 and 255.
Note : a projector will respond to a RCU set to the common address ('0' or '1') regardless of what address is set in the projector itself.
Before using the RCU.
The RCU is default programmed with address 0 or 1, 'common address'. Every projector, without exception will listen to the commands
given by this RCU.
If it is necessary to control a specific projector, enter the projector address into the RCU, the projector with the corresponding address
will listen to that specific RCU.
Common Address
Every projector has a common address '0' or '1'. The choice between '0' and '1' can also be selected in the "Installation"menu.
Displaying the Projector Address on the Screen.
Press the ADDRESS key (recessed key on the RCU) with a pencil. The projector's address will be displayed in a 'Text box'. This
text box disappears after a few seconds.
How to Program an Address into the RCU?
To use the RCU with a specific address, it is necessary to enter the address with the digit buttons (address between 0 and 9) within
5 seconds after pushing the address key. For example : if the Address key displays projector address 003, then press "3" digit button
on the RCU to set the RCU's address to match the projector's address. Do not press 003, this will address the remote control to
'0' and control all projectors in the room.
If the address is not entered within 5 seconds, the RCU returns to its default address (zero address) and controls all projectors in
the room.
Address 0 (or 1) should always allow communication with the projector since it is a common adress.
Projector RC5 address
3URMHFWRUDGGUHVVHV
0 Common RC5 address
0