Barco IQ-Graphics 300, Руководство пользователя

Страница: 33 / 94

5-3
Getting Started
5976367 BARCO IQ-G300 24092001
Operating the Projector
Switching on
Use the power switch to switch on.
When '0' is pushed in, the projector is switched off.
When '1' is pushed in, the projector is switched on.
When switching on with the power switch, the projector starts in the stand by mode. The projector mode indication LED (LED3)
is red.
To start image projection :
press the 'Stand by' button once on the local keypad or on the remote control
or,
press a digit button to select an input source.
It may take about 30 seconds before image projection, i.e the shutter remains closed until the completion of several operations
(software initialisation, input scanning,...).
Lamp Run Time
Independently of the lamp mode (see Chapter 11 for more detail about the lamp modes), when the total run time of an active lamp
(lamp1 for example)is 1470 hours or more, a warning message will be displayed. This warning message will be repeated at the
next start up. Press
BACK
or MENU to remove the message.
When the lamp runtime reaches 1500 hours the projector switches automaticaly to the other lamp, being lamp2.. following messages
are displayed during and after switching.
When lamp2 at its turn reaches 1470 hours, a warning message appears on the screen.
At the end of the lifetime of lamp2 (1500 hours) the projector generates an alert message.
A coutdown time of 4 minutes is triggered before the projector is shut down (standby).
If the lamp runtime has not been reset, the alert message will reappear at the next start up (with again 4 minutes coutdown time).
This alert message can be escaped with MENU or BACK, but the countdown continues.
Contact a qualified Barco technician for lamp replacement.
In dual mode the lamp end of lifetimes are reached at the same time, however if in dual lamp mode one lamp has been used more
than the other (for example if the projector has been working temporarily in single mode), one lamp will reach its end of lifetime
sooner than the other lamp, which brings us to the single mode operation.
WARNING !
Using a lamp for more than 1500 hrs is dangerous as the lamp could explode. The lamp runtime reset
as well as the lamp replacement can only be done by a Barco authorised technician.
LAMP 1 : 1471 hrs
LAMP 2 : 1400 hrs
LAMP 1 : 1500 hrs
LAMP 2 : 1471 hrs
No lamps available anymore
Projector will go to standby
04:00
Switching to other lamp
Message
Switched to other lamp
Message