Barco Coronis 5MP Mammo, Руководство по началу работы, Страница: 31 / 88

Display Controller Installation
31
Installation Procedure
The following instructions will take you step by step through the
installation of the display controller(s) for your B
ARCO
C
ORONIS
5MP
M
AMMO
Display System.
1.
If you are not going to use your old graphics card, uninstall the
drivers and software for it if you have not already done so.
2.
Turn off the computer, display(s), and other peripheral devices.
3.
Unplug the computer’s power cord and disconnect all cables
from the back of your computer.
4.
Remove the computer cover.
If necessary, consult your computer’s manual for help in
removing the cover.
5.
If necessary, unscrew or unfasten and remove any existing
graphics card(s) from your computer.
Note:
If you are using a motherboard containing an on-board
graphics solution and do not intend to use it as part of a
multiple-display setup, disable it either in the computer’s
System Set-up utility (BIOS) or the Windows device manager.
6.
Locate the appropriate slot and, if necessary, remove the metal
back-plate cover(s).
CAUTION –
Wear a grounded, protective ESD strap when
handling or during installation of the display controller.
Electrostatic charges can damage the display controller.
Caution
– Wait approximately 20 seconds after unplugging
the power cord before disconnecting a peripheral or
removing a component from the motherboard to avoid
possible damage to the motherboard.