Barco CORONIS 1MP, Системное руководство

Страница: 69 / 113

System manual Coronis 1MP 70
BarcoMed software driver installation
Installing the BarcoMed 3MP2FH, 2MP2FH or
1MP2FH Windows 2000 or Windows XP Soft-
ware
Using the BarcoMed Product Installation Wizard
SPECIAL NOTE: Prior to installing the BarcoMed drivers and related
software you MUST install the BarcoMed Display Controller(s),
connect the CORONIS display panel(s) to the controller(s), and turn
the CORONIS display panel(s) on. Refer to the Hardware Installation
section of this manual for instructions on installing the BarcoMed
Display Controller(s) and connecting them to the CORONIS display
panel(s).
The following software installation instructions presume that
Windows is already installed on your system. If you need to install or
reinstall Windows on your system you must first remove the
BarcoMed Display Controller(s) and use a 3
rd party VGA card and VGA
monitor during the Windows installation process.
To install your BarcoMed 3MP2FH, 2MP2FH or 1MP2FH Windows
Display Controller Driver, BARCO DPMS Screen Saver and
CORONIS Rotation Service for the first time follow the steps below. If
you are reinstalling the drivers or installing a new driver release over
an existing driver release skip to step 5:
1. Install the BarcoMed Display Controller(s) into your machine.
Please refer to the hardware installation section of this manual
for more information.
2. Boot the machine, and log in using an account with administrator
privileges.
3. For each BarcoMed display controller installed in your system
Windows will launch the “Found New Hardware Wizard”. Click
“Cancel” . Continue to click “Cancel” until Windows stops
launching the “Found New Hardware Wizard”. Please be patient
as this may take several minutes while Windows scans its library
of Plug-and-Play device drivers to see if it has a driver for your
BarcoMed display controller.
4. Windows may advise you that it has finished installing all the new
devices in your system and that you must reboot your system in
order for the changes to take effect. If it does, Click
“No” .
5. Insert your CORONIS Software CD into your computer’s CD drive.
The “BarcoMed Product Installation Wizard” should start
automatically. If it doesn’t start within 1–2 minutes, browse the
contents of your CORONIS Software CD and double click on the
file:
“Setup.exe” to start the wizard.