Barco CORONIS 1MP, Системное руководство

Страница: 106 / 113

System manual Coronis 1MP 107
BarcoMed software driver installation
after the time specified has elapsed when you are in Stand-By or
Suspend, you will automatically go into the Off state.
8. Select the amount of time it takes for your display to warm up. If
you have a Barco Medical Display, select “Barco Quick Start” . If
you are using a non-Barco display, select the amount of time it
takes your display to warm up via the “Monitor Setting” section.
Contact your display vendor for this warm-up time. On Barco
CORONIS displays, the I-GUARD will stabilize the image within a
few seconds after the display returns to the active state, thus
eliminating the need for a warm-up period at the beginning of the
work day.
9. If you wish to use this DPMS screen saver as the screen saver at
logon time, check the “Use As Logon Screen Saver” box in the
“Additional Options” section.
10. Save your preferences by pressing the “Save As” button and
entering a new profile name in the “Save Profile Setting” dialog
box.
11. Apply your new scheme by clicking “OK”.
12. Click “OK” again to close the “Display Properties Control Panel”.
Installing or Reinstalling BARCO DPMS
To install or reinstall the BARCO DPMS Screen Saver insert the
CORONIS Software CD in the appropriate device on your computer
and run the BarcoMed Product Install Wizard (please see the section
Software Installation for complete instructions).
Special Note: Reinstalling the BARCO DPMS Screen Saver will over
write the DPMS configuration settings and you will need to
reconfigure the DPMS settings on your system.
Uninstalling BARCO DPMS
To remove the BARCO DPMS Screen Saver from your system insert
the CORONIS Software CD in the appropriate device on your
computer, run the BarcoMed Product Install Wizard and follow these
steps.
1. Select only the DPMS Screen Saver on the BarcoMed Product
Install Wizard’s welcome screen and click “Install” .
2. Click “Next” on the Welcome Screen of the BARCO DPMS
InstallShield Wizard to begin the installation.
3. Select the radio button next to “Remove” on the Program
Maintenance screen of the Wizard and click “Next” (see figure 32
on the next page).