Barco ClickShare CSE-200, Руководство по установке

Страница: 25 / 85

3. Getting started
3. GETTING STARTED
Overview
• Environmental Condition Check
• Basic Work fl ow
3.1 Environmental Condition Check
Environment condition check
For installations in environments where the device is subject to excessive dust, then it is highly advisable and desirable to have this
dust removed prior to it reaching the device clean air supply. Devices or structures to extract or shield excessive dust well away
from the device are a prerequisite; if this is not a feasible solution then measures to relocate the device to a clean air environment
should be considered.
It is the customer’s responsibility to ensure at all times that the device is protected from the harmful effects of hostile airborne particles
in the environment of the device. The manufacturer reserves the right to refuse repair if a device has been subject to negligence,
abandon or improper use.
Ambient temperature conditions
Max. ambient temperature : +40°C or 104°F
Min. ambient temperature: +0°C or 32°F
Storage temperature: -10°C to +60°C (14°F to 140°F)
Humidity Conditions
Storage: 0 to 90% relative humidity, non-condensing
Operation: 0 to 85% relative humidity, non-condensing
Environment
Do not install the device in a site near heat sources such as radiators or air ducts, or in a place subject to direct sunlight, excessive
dust or humidity. Be aware that room heat rises to the ceiling; check that temperature near the installation site is not excessive.
3.2 Basic Work fl ow
Before using CSE-200
1. Unpack the ClickShare components and accessories from the box.
For a detailed overview of the content of the CSE-200 box, see "About the CSE-200", page 5 .
2. Install the Base Unit in the meeting room using one of the 2 possible installation methods.
For more information on the installing procedures, see "CSE-200 Installation", page 15
3. Connect the video signal between the Base Unit and the display.
4. Connect the audio from the Base Unit to the meeting room’s sound system (only required for audio via jack or SPDIF).
5. If con fi guration via a network is needed, connect a network cable between the Base Unit and the local network (if not yet done
to power the Base Unit).
6. Connect the Base Unit to the mains power (optional if Ethernet supports PoE+.
For more information see "Power connection", page 18,
7. If desired, con fi gure CSE-200 via the Con fi gurator.
For more information on the different ways to con fi gure CSE-200, see "CSE-200 Con fi gurator", page 25
For more information on using CSE-200, refer to the CSE-200 User Guide. This manual can be found on Barco’s
website
www.barco.com/clickshare Click on Visit the ClickShare product page and go to tab Downloads..
R5900023 CLICKSHARE CSE-200 13/07/2016 13