![background image](http://html.mh-extra.com/html/barco/cine-8-r9002390/cine-8-r9002390_owners-manual_473933023.webp)
Getting Started
3-3
5976064 BARCOCINE 8 25012000
1
Function keys : user programmable keys with functions for direct access.
2
ADJ. : ADJUST key, to enter or exit the adjustment mode.
3
Address key (recessed key), to enter the address of the projector (between 0 and 9). Press the recessed address key with a pencil,
followed by pressing one digit button between 0 and 9.
4
Selection key : no function for this projector
5
PAUSE : to stop projection for a short time, press 'PAUSE'. The image disappears but full power is retained for immediate
restarting.
6
STBY : stand-by button, to start projector when the power switch is switched on and to switch off the projector without switching
off the power switch.
7
Mute : no function in this projector
8
Help : on line help information (not yet available)
9
Digit buttons : direct input selection.
10 Audio controls : no function in this projector
11 Picture controls : use these buttons to obtain the desired picture analog level.
12 PHASE : used to remove the instability of the image.
13 FREEZ : press to freeze the projected image.
14 TEXT : when adjusting one of the image controls, e.g. contrast, during a meeting, the displayed bar scale can be removed by
pressing 'TEXT' key first. To re-display the bar scale on the screen, press 'TEXT' key again.
15 ENTER : to start up the adjustment mode or to confirm an adjustment or selection in the adjustment mode.
16 Cursor Keys : to make menu selections when in the adjustment mode.or to increase or decrease the analog level of the image
controls when they are first selected.
17 EXIT : to leave the adjustment mode or to scroll upwards when in the adjustment mode.
18 RC operating indication : lights up when a button on the remote control is pressed. (This is a visual indicator to check the
operation of the remote control)
Operating the Projector
Switching on
The projector is switched ON using the power (mains) switch ON/OFF.
Pressed : ON state
Not pressed : OFF state
The projector can start now in :
- Operational mode (picture displayed)
- Stand by mode
Depending on the position of the 'Power up' dip switch on the controller unit. This DIP switch is set during installation by a qualified
technician. If you want to change this start up mode, call a qualified techician.