Lighting Your Grill by Match
To light your gas grill by match, open the hood and light a
match. Turn the Right Main Burner Control Knob to the High
setting to release the gas while holding the lit match over the
lighting tube as shown in
Figure 41
. The burner should light
within 5 seconds. If it fails to light, turn the valve off and wait
5 minutes before attempting to manually light the burner
again.
Occasionally observe the burner flame for correct operation.
Once the left main burner is alight, the adjacent burner can
be turned on and it will cross light off the operating burner.
Repeat for each burner in turn.
WARNING
Never
lean over the grill cooking area while lighting your gas
grill. Keep your face and body a safe distance (at least 18
inches) from the lighting hole or burners.
If the grill fails to light properly:
1.
Turn gas off at source and turn the control knob to OFF.
Wait at least five minutes for gas to clear, then retry.
2.
Check gas supply and connections.
3.
Repeat lighting procedure. If your grill still fails to oper-
ate properly, turn the gas off at source, turn the control
knobs to OFF, then check the following:
Misalignment of burner tubes over orifices
Correction:
Reposition burner tubes over orifices.
Obstruction in gas line
Correction:
Remove fuel line from grill. Do not smoke!
Open gas supply for one second to clear any obstruction
from fuel line. Close off gas supply at source and recon-
nect fuel line to grill.
Plugged orifice
Correction:
Remove burners from grill by pulling cotter
pin (beneath burner) using a screwdriver or pliers.
Carefully lift each burner up and away from gas valve
orifice. Remove the orifice from gas valve and gently
clear any obstruction with a fine wire. Then reinstall all
orifices, burners, cotter pins and cooking components.
If an obstruction is suspected in gas valves or gas valve
bracket, please call the Members Mark service center or
your local propane dealer for assistance.
Misalignment of ignitor on burner
Correction:
Check for proper position of the electrode
tip as shown in ILL. 4. The gap between the Spark
Electrode Tip and Spark Receiver should be approxi-
mately 3/16”. Adjust if necessary. With the gas supply
closed and all control knobs set to OFF press the elec-
tric ignitor cap and check for the presence of a spark at
the electrode.
Disconnected Ignition Wires
Correction:
Inspect the Ignitor junction box found
behind the Control Panel. Connect loose Ignitor wires to
junction box and try to light the grill.
Weak AA battery
Correction:
Unscrew the Ignitor Cap and replace the
battery.
18
Match Light
Tube
Figure 41
Questions? Call our Grill Information Center: 1-800-
752-3085
Monday thru Friday 8:00 am - 4:30 pm PST
Figure 42
Содержание Grand Endevator GE3BSSLP
Страница 2: ......
Страница 9: ...8 PARTS DIAGRAM MODELS GE3BSSLP GE3BSSNG Figure 13 ...
Страница 10: ...9 PARTS DIAGRAM MODELS GE4BSSLP GE4BSSNG Figure 14 ...