Barbeques Galore Grand Endevator GE3BSSLP, Руководство пользователя

Страница: 14 / 38

Ignitor Battery Installation
1. Unscrew Igniter Cap(s) located on the grill Control
Panel and remove the Contact(s) and Spring(s) from
the Battery Holder(s).
2. Place an “AA” battery into Battery Holder(s). Be sure
to place the positive pole facing toward you. See
Figure 19.
3. Place the Spring over the AA battery, then place the
Contact on top of the Spring. Screw Igniter Cap(s)
back onto the grill Control Panel.
Electrode Check - Requires an Assistant
Before placing the cooking components into your grill,
ensure that the Spark Electrode Tip is properly positioned
within each Gas Collector Box (a stainless mechanism found
at the front between each set of Burners.) The easiest way
to ensure this is to perform this Electrode Check:
1. Be sure all Control Knobs are set to ”OFF” and open the
Grill Lid.
2. Have an assistant stand behind to the right of the grill and
look down at each Gas Collector Box. NEVER put your
face inside Grill Head.
3. Press the Ignitor Cap. You should hear a "clicking" sound
and your assistant should see a small blue spark within
each Gas Collector Box. If a spark is present the
Electrode Tips are properly positioned.
4. If no spark is seen, the Spark Gap, as shown in Figure 20
needs to be adjusted as follows:
Using an adjustable wrench, loosen the Inside Nut just
until the Gas Collector Box can be maneuvered and
turned upward.
The gap between the Spark Electrode Tip and Spark
receiver should be approximately 3/16”.
if the gap is wider than 3/16” use a pair of long nose pli-
ers and gently squeeze the Gas Collector Box until the
gap is correct.
Return the Gas Collector Box to its original horizontal
position, secure the Inside Nut and try the Electrode
Check again.
4. If no "clicking" sound is heard check the following com-
mon causes. If you need assistance call the Grill
Information Center at 1-800-
752-3085
.
Ignitor AA battery not installed properly.
Electric wires may be loose. Remove the AA battery,
inspect the Ignitor Junction Box found behind the
Control Panel, and connect any loose wires.
lnstalling Cooking Components
Important: Before cooking on your grill for the first time,
wash the cooking grids and warming rack with warm, soapy
water. Rinse and dry thoroughly. Season with cooking oil
regularly. After cooking is completed, turn grill to HIGH set-
ting for about five minutes to burn off excess grease or food
residue.
1. Place the Stainless Steel Flame Tamers on the lower
ledge above the burners. Note: Right Side Flame
Tamer has gap for lighting tube ( Figure 21 & 22 ).
13
IGNITOR
CAP
SPRING
“AA” BATTERY
IGNITOR
SLOT
-
+
Figure 19
GAS COLLECTOR BOX
SPARK RECEIVER
3/16" SPARK GAP
SPARK ELECTRODE TIP
INSIDE NUT
Figure 20
-
+
Figure 21
Figure 22
Lighting
Tube
Lighting
Tube
Right Side S/S
Flame Tamer
with cutout
Burner