3.2.6 Gain and Sensitivity
Use this menu to set the excess gain mode. This menu is only available when a 15, 25, or 50 millisecond response speed is
selected. It is not available for 3 or 5 millisecond response speeds.
•
—High excess gain mode
•
—Standard excess gain mode with increased noise immunity
3.2.7 Output Timing Delays
Use this menu to select the output timing delay to be set. On and off delay timers can be used together. The default is no
delay. For Channel 2, this menu is available when the output is set to light operate or dark operate.
Note: The number that follows dLY on the display indicates which channel is selected.
•
—No delay
•
—Delay—enables the selection of on and off delay timers
•
—One-shot—enables a one-shot, fixed output pulse duration
•
— Totalizer—enables an output after a defined number of targets are counted
Output
OFF Delay
ON Delay
Time
1-Shot
ON
OFF
D
D
D
D
D
D
(D = 1ms - 90.0s)
Figure 17. Output Timing Delays
When one of the timing delay options is chosen, the sensor returns to the Setup menu and additional options become
available to set the parameter(s):
•
—On delay
•
—Off delay
•
/
—One-shot delay timer
Note: For the one-shot delay timer:
• LO = On pulse when a target is detected inside of the switch point(s)
• DO = On pulse when a target is detected outside of the switch point(s)
•
/
—Output duration
•
/
—Number of counts before an output change
Q5X Laser Triangulation Sensor with Background Suppression
www.bannerengineering.com - Tel: +1.763.544.3164
13
