Banner DF-G3 Long Range Expert, Инструкция по эксплуатации

Страница: 13 / 36

3.2.6 Delays/Timers
ON/OFF Delays and ON/OFF One-Shot timers
can be programmed independently for both CH1
and CH2 for a time period between between 1 -
9999 ms (a value of 0 disables the delay/timer).
Figure 3 on page 13 defines how the delays/
timers affect the output behavior.
Some combinations of delays/timers are not
allowed. The DF-G3 programming menu
automatically disables invalid combinations of
delays/timers. The following table shows the
allowable combinations of delays/timers:
Output
OFF Delay
ON Delay
Time
OFF 1-Shot
ON 1-Shot
ON
OFF
D
D
D
D
D
D
D
D
(D = 1 - 9999 ms)
Figure 3. DF-G3 Delays/Timers
OFF Delay OFF One-Shot Timer ON Delay ON One-Shot Timer
OFF Delay - OK OK N/A
OFF One-Shot Timer OK - N/A N/A
ON Delay OK N/A - OK
ON One-Shot Timer N/A N/A OK -
3.2.7 Sensitivity Selection
The Sensitivity Selection can be programmed independently for CH1 and CH2. Use this setting to increase (lo) or decrease (high) the
switch-point hysteresis from the default (std) setting.
• high—High sensitivity. Use this setting for low contrast sensing
• Std—Standard sensitivity
• Lo—Low sensitivity. Use this setting to stabilize the output in high vibration applications
3.2.8 Input Wire Function
The DF-G3 can be programmed for one of the following input wire functions:
• Off—Ignore all pulses
• Set—Remote TEACH input
• Master—Master sync line output for multi-sensor cross-talk avoidance
• Slave—Slave sync line output for multi-sensor cross-talk avoidance
• LED off—When the input wire is active the emitter LED turns off
• LED on—When the input wire is active the emitter LED turns on
• Gate—When the input wire is active the outputs are locked in their present state; any active delay timers are paused
For remote programming in Set Mode see Remote Input on page 14.
To configure sensors for master-slave operation, see Sync Master/Slave on page 15.
3.2.9 Display Readout
The readout of the digital displays can be programmed for the following options:
• Signal/Threshold readout - Numeric (1234) or % (123P)
• ECO mode - Enabled or Disabled (ECO mode dims the displays to reduce current consumption)
• Display Orientation - Normal ( ) or Flipped ( )
DF-G3 Long Range Expert
™
Dual Display Fiber Amplifier
www.bannerengineering.com - Tel: 763.544.3164 13