Installation and wiring
3. Install the retaining clips on the device. To do this, insert all retaining clips into the recesses (marked with
orange circles) on the device. The number of retaining clips can vary depending on the panel; for the exact
number, see the individual
4. Slide the retaining clips all the way to the back of the openings.
5. Now fasten the retaining clips to the wall or control cabinet by tightening the screws with a flat-blade screw-
driver. The tightening torque should be approximately 0.5 Nm.
Information:
The retaining clips are designed to clamp material thicknesses up to 6 mm, but mounting using a
retaining frame is specified for material thicknesses up to 3 mm.
Automation Panel 1000 - Hygienic design user's manual V2.00
59
