Manual Documentation Number: EIRM-EXTEND-8-1
m
133
B&B Electronics Mfg Co Inc – 707 Dayton Rd - PO Box 1040 - Ottawa IL 61350 - Ph 815-433-5100 - Fax 815-433-5104 – www.bb-elec.com
B&B Electronics – Westlink Commercial Park – Oranmore, Galway, Ireland – Ph +353 91-792444 – Fax +353 91-792445 – www.bb-europe.com
VLANID The VID of the VLAN that will be enabled or disabled on the
bridge <2-4094>.
GROUP <1-1> The ID of the bridge-group on which the VLAN will be
affected.
VLAN_NAME The ASCII name of the VLAN. Maximum length: 16
characters.
enable Sets VLAN into an enable state.
disable Sets VLAN into a disable state.
4.
Example:
The following example enables the vlan VLANID (
2
) and name
VLAN_NAME (
vlan2
) of bridge GROUP (
1
):
switch_a(config-vlan)#vlan 2 bridge 1 name vlan2 state enable
switch_a(config-vlan)#
802.1Q Port Setting
Switchport mode access:
1.
Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
fe1 means port 1.
The
switch_a(config-if)#
prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if)#
2.
Usage:
Use
switchport mode access
command to set the switching characteristics
of the Layer-2 interface to access mode, and classify untagged frames only.
Use the
no switchport access
command to reset the mode of the Layer-2
interface to access (default).
3.
Command Syntax:
switchport mode access
no switchport access
4.
Example:
The following example sets the
switchport mode access
of the interface
fe1 (port 1):
switch_a(config)#interface fe1
switch_a(config-if)#switchport mode access
switch_a(config-if)#