Balluff IO-Link BLA D Series, Руководство пользователя

Страница: 31 / 48

www.balluff.com 7 english
Fig. 3-2: Holder dimensions for emitters BLA 72D und BLA 100D
3.2 Electrical connections
Connect the emitter and receiver using a 4-conductor
cable (all conductors through-connected 1:1). The emitter
has an M12 male plug and the receiver an M12 female.
A M12 male plug is used for power supply and data
output.
Standard IO-Link
Pin Strand
colour
Function Pin Strand
colour
Function
1 white Digital output 1 1 brown +Ub
(18…30 V)
2 brown +Ub
(18…30 V)
2 white not used
3 green Analog output 1
(0-10 V or 4-20 mA)
3 blue Ground 0 V
4 yellow Digital output 2 4 black IO-Link
5 grey Analog output 2
(0-10 V or 4-20 mA)
6 pink Digital output 3
7 blue Ground 0 V
8 red Analog Ground
Tab. 3-1: Pin assignment
3.1 Installation
Mounting instructions
– Install the devices solidly on a stable, vibration-free
holder.
– Be sure that the orientation of the devices cannot
change during startup or in normal operation.
Especially the emitter and receiver must not be
permitted to move relative to each other, since
otherwise incorrect measurements and failed object
detection can result.
– Locate the devices where they are protected against
the accumulation of dust, dirt or liquids.
– Do not install the devices in a location where they are
exposed to direct sunlight or strong ambient light,
since excessive ambient light can result in faulty
measurements.
The device can be installed horizontally or vertically.
Fastening options:
Custom fastening system
Two M4 screws are used for fastening. Use either two of
the three through holes on the top side or the two threa-
ded holes on the side.
Mounting brackets from Balluff
The supplied stainless steel mounting brackets allow
flexible positioning and easy alignment of emitter and
receiver by slotted holes.
Fig. 3-1: Holder dimensions for all receivers and emitters
BLA 32D and BLA 50D
3
Installation
BLA Series D
Balluff Light Array