Baldor VS1MXS51, Инструкция по установке и эксплуатации

Страница: 75 / 88

CE Guidelines C-1 MN762S
Appendix C
CE Guidelines
C.1 CE Declaration of Conformity
Baldor indicates that the products are only components and not ready for immediate or instant use
within the meaning of “Safety law of appliance”, “EMC Law” or “Machine directive”. The final mode of
operation is defined only after installation into the user’s equipment. It is the responsibility of the user
to verify compliance.
C.2 EMC - Conformity and CE Marking
The information contained herein is for your guidance only and does not guarantee that the installation
will meet the requirements of the council directive 89/336/EEC.
The purpose of the EEC directives is to state a minimum technical requirement common to all the
member states within the European Union. In turn, these minimum technical requirements are
intended to enhance the levels of safety both directly and indirectly. Council directive 89/336/EEC
relating to Electro Magnetic Compliance (EMC) indicates that it is the responsibility of the system
integrator to ensure that the entire system complies with all relative directives at the time of installing
into service.
Motors and controls are used as components of a system, per the EMC directive. Hence all
components, installation of the components, interconnection between components, and shielding and
grounding of the system as a whole determines EMC compliance.
The CE mark does not inform the purchaser which directive the product complies with. It rests upon
the manufacturer or his authorized representative to ensure the item in question complies fully with
all the relative directives in force at the time of installing into service, in the same way as the system
integrator previously mentioned. Remember, it is the instructions of installation and use, coupled with
the product, that comply with the directive.
Note that this drive is commercial in design; not for residential environments.
Wiring of Shielded (Screened) Cables
Figure C-1
Remove the outer insulation to
expose the overall screen.
Conductive
Clamp
Shielded Couplings
360 Degree Coupling
360 Degree
Coupling
Conductive
360 Degree Clamp
A B
C
d
A = </-30mm
B = 500mm max.
C = <30mm