Baldor ID15J101-ER, Инструкция по установке и эксплуатации

Страница: 52 / 89

MN715J Programming and Operation 4-15
Parameter Block Definitions Level 1 Continued
OUTPUT
Continued
Fault Active when a fault condition is present.
Drive On Active when control is “Ready” and is being commanded to operate the
motor.
Reverse Active when control is operating in the reverse direction.
Process Error Active when the PID control loop process is outside the range
specified by the Level 2 Process Control block, AT Setpoint band parameter.
Zero SPD Set PT The output frequency at which the zero speed relay output becomes
active (turns on). When the output frequency is less than the Zero SPD Set PT, the
relay output becomes active. This is useful in applications where a motor brake will be
interlocked into the operation of the motor control.
At Speed Band A frequency band within which the at speed relay output becomes
active (turns on). For example, if the at speed band is set to
±
5Hz the relay output
becomes active when the output frequency to the motor is within 5Hz of the
commanded motor frequency. This is useful when another machine must not start (or
stop) until the motor reaches operating speed.
Set Speed Point The frequency at which the at set speed relay output becomes active
(turns on). When the frequency is greater than the set speed point parameter, the
relay output becomes active. This is useful when another machine must not start (or
stop) until the motor exceeds a predetermined speed.
Overload Set Point When the output current exceeds this value, the overload output is
turned on.
Underload Set Point When the output current is less than this value, the underload
output is turned on.
Analog OUT Type 0-10VDC, 0-5VDC, 4-20mA or 0-20mA.
Analog Output Analog output that may be configured to represent one of the
following conditions:
Frequency Represents the output frequency; where max output = MAX Hz (slip
freq. compensation is not included).
Freq Command Represents the commanded frequency where max output =
MAX Hz.
AC Current Represents the value of the output current where max output = Full
load current (A
RMS
).
AC Voltage Represents the value of the output voltage where max output =
Control Input Voltage.
Bus Voltage Represents motor power where half max output = 325VDC for
230VAC input (650VDC for 460VAC input).
Control Temp Represents the heat sink temperature of the control where max
output = maximum heat sink temperature.
Process Feedback Represents the process feedback signal where max output =
100% feedback signal.
Set Point Command Represents the setpoint command value where max output
= 100% commanded value.
Zero Cal Output is minimum used to calibrate an external meter.
100% Cal Output is maximum used to calibrate an external meter.
Analog Scale Scale factor for the Analog Output voltage.
Useful to set the full scale range for external meters.