Baldor 23H Series, Инструкция по установке и эксплуатации

Страница: 94 / 127

SYMPTOM POSSIBLE CAUSE CORRECTIVE ACTION
POWER BASE FLT Broken or misaligned encoder coupling. Check encoder coupling: align or replace.
Encoder bearing failure. Replace encoder and align during installation.
Excessive current draw. Disconnect motor wiring and retry. Contact
Power device desaturated. factory if fault remains.
Excessive noise on encoder signals. Check encoder connections. Separate encoder
leads from power leads. Cross power leads at
90°. Isolate encoder from motor electrically.
Install optional Isolated Encoder Feedback
expansion board.
Electrical noise from external DC coils. Install diodes on all external DC relay coils. See
manual, Opto-Isolated Outputs.
Electrical noise from external AC coils. Install RC snubbers on all external AC coils.
Drive overloaded. Verify sizing of motor and control for
application.
POWER MODULE FLT Power supply malfunction in multiaxis Push RESET key. If problem remains replace
shared bus system. power supply module.
REGEN PWR FLT Incorrect Dynamic Braking parameter Check RESISTOR OHMS and RESISTOR
settings. WATTS settings in Level 2 BRAKE ADJUST
parameter block.
Regen power exceeded Dynamic Braking Resize and replace DB resistor(s).
resistor rating.
Input voltage too high.
Verify proper incoming line voltage.
Use transformer to step down voltage.
Use line reactor to minimize voltage spikes.
UNKNOWN FAULT Fault occurred but was not sustained Check AC line for high frequency noise and input
long enough to record the source of fault. switches for good contact.
USER FAULT TEXT Fault peculiar to custom software Refer to custom software fault list.
detected.
WRONG RESPONSE Input common mode voltage may be Connect control input source common to control
TO SPEED COMMAND excessive. common to minimize common mode voltage.
Continued on next page...
4-11 DIAGNOSTIC INFO AND TROUBLESHOOTING
MN723H-10/95 11/28/95 1:14 AM Page 95 (Black plate)