Baldor 23H Series, Инструкция по установке и эксплуатации, Страница: 53 / 127

Minimum Required Parameter Settings and Control Set-up Checklist
If you are familiar with programming Baldor controls continue below. If not, proceed to Section 3
before applying power to the drive.
NOTE: THIS LIST IS THE MINIMUM REQUIRED PROCEDURE TO PROGRAM THE
CONTROL FOR OPERATION OF THE CONTROL FROM THE KEYPAD FOR
INITIAL START-UP.
1. Set the operating mode to KEYPAD at the Level 1 Input block Operating Mode parameter.
2. Select the desired operating zone for your application into the Level 2 Output Limits block
Operating Zone parameter.
3. Enter the minimum speed in the Level 2 Output Limits block, Minimum Speed parameter.
4. Enter the maximum speed in the Level 2 Output Limits block, Maximum Speed parameter.
5. Enter the following motor data in the Level 2 Motor Data block parameters:
Refer to Section 3-15 Motor Data Block
Motor Rated Amps (IC)
Motor Poles
Resolver Speeds (Pre-set is one speed)
6. Go to the Calc(ulate) Presets parameter in the Auto-tuning parameter block on Level 2. Select
"Yes" for the control to calculate preset values for those parameters you have not
programmed that are necessary for the control to run the motor.
7. Disconnect the motor from the load (including any coupling and/or inertia wheels).
8. Run the following Auto-tuning tests:
Cmd Offset Trim
Cur Loop Comp
Resolver Align
Spd Cntrlr Calc
9. Couple the motor to the load. Then rerun the Spd Control Calc auto-tuning test.
10. Run the drive from the keypad using either the JOG mode, keypad entered speed commands
or speed commands using the arrow keys.
11. Select and program additional parameters to suit your application.
2-42 INSTALLATION
MN723H-10/95 11/28/95 1:11 AM Page 54 (Black plate)