Baldor 23H Series, Инструкция по установке и эксплуатации

Страница: 58 / 127

Display Mode
During normal operation the controller is in the DISPLAY MODE and the keypad displays the status
of the control. There are several output status values that can be monitored. When the control is in
the DISPLAY MODE the information shown below is displayed.
In addition, the DISPLAY MODE offers a combined display that gives the value of all output
conditions simultaneously. The DISPLAY MODE also gives the user the ability to view diagnostic
information and the FAULT LOG.
When AC power is applied to the control the keypad should display the status of the control. Also
the fans should be running (if equipped with fans). If there is no display visible , check to make sure
that the brightness and contrast settings for the keypad display are correctly set. Use the following
procedure to adjust the brightness and contrast of the display.
Motor Status Output Condition
Control Operation Value and Units
Adjusting Display Contrast
(Contrast may be adjusted in display mode when motor is stopped or running)
3-5 KEYPAD PROGRAMMING AND OPERATION
Action Description Display Comments
Apply Power No visible display
Press
DISP
Key Ensures control in
display mode
Press
SHIFT SHIFT
Enables display
contrast adjustment
Press or Key Adjusts display
intensity
Typical display
Press
ENTER
Saves level of contrast
and exits to display
Typical display
B L A N K
B L A N K
B L A N K
STPMOTOR SPEED
LOCAL 0 PRM
STPMOTOR SPEED
LOCAL 0 PRM
OFFMOTOR SPEED
LOCAL Ø RPM
MN723H-10/95 11/28/95 1:11 AM Page 59 (Black plate)