![background image](http://html1.mh-extra.com/html/balboa/tp200-panel/tp200-panel_user-manual_468577020.webp)
TP200
USER GUIDE
42369 Rev A2
36
35
Balboa Water Group | Your Single Source Solution
PANEL MESSAGES
REMINDER
GFCI Failure - System Could Not Test/Trip the GFCI.
NORTH AMERICA ONLY. May indicate an unsafe installation.
Contact your dealer or service organization.
Message
Code *
A Pump Appears to be Stuck ON.
Water may be overheated.
POWER DOWN THE SPA. DO NOT ENTER THE WATER.
Contact your dealer or service organization.
Message
Code *
A Pump Appears to have been Stuck ON when spa
was last powered.
POWER DOWN THE SPA. DO NOT ENTER THE WATER.
Contact your dealer or service organization.
Message Code *
*
* *
View page 55 for instructions on how to review the Fault Log that corresponds with the Message Code.
This message can be reset from the panel with any button press.
Check pH
This message may appear every 7 days. Check
the pH of your spa’s water with a pH test kit,
and adjust pH with the appropriate chemicals.
General maintenance
helps your spa.
Reminder messages alternate with the
Main Screen.
Reminder Messages can be chosen
individually by the Manufacturer. They may
be disabled entirely, or there may be a limited
number of Reminders on a specific model.
The frequency of each Reminder (i.e. 7 days)
can be specified by the Manufacturer.
Press a Temperature button to reset a
displayed Reminder Message.
The display of Reminder Messages can be
turned On/Off (view page 43).
Check the sanitizer chemicals
This message may appear every 7 days.
Check sanitizer level and other water
chemistry with a test kit and adjust with the
appropriate chemicals.
Clean the water filter.
This message may appear every 30 days.
Clean the filter media as instructed by the
manufacturer. See Hold Mode on page 14.
Main Screen
The water level is too low.
Some systems have a water level detector, and this message
appears if it detects that the water level is too low. Pumps are
shut down until this problem clears.