Page 6
EL1500 - 40916_01_C
DIP Switches and Jumpers Definitions
WARNING:
s
Setting DIP switches incorrectly may cause abnormal system behavior and/or damage to system components.
s
Refer to Switchbank illustration on Wiring Configuration page for correct settings for this system.
s
Contact Balboa if you require additional configuration pages added to this tech sheet.
DIP Switchbank A Key
A1
.............Test Mode (normally Off)
A2
.............See Table 1
A3
.............See Table 1
A10 .............When switched ON when spa is on, system will enter the Edit Menu
for Configuration Settings.
Do not start spa with A10 turned on or CFE* error will occur
A11
.............In “ON” position, enables Special Amperage Rule, see "SA" in Software
Configuration section for functionality with your system
..............In “OFF” position, disables Special Amperage Rule
A12 .............Persistent memory reset (used when spa is powering up) See "Persistent Memory and Powering Up" page
*CFE errors are illegal configurations such as a pump and a blower set to run on the
same output. The configuration must be corrected before the spa will operate.
Assignable DIP Switch Key
A4
.............In “ON” position, Filter cycles are programmed by duration
..............In “OFF” position, Filter cycles are programmed by time
A5 and A6........See
Table 2
for Circ Pump Behavior settings
A7 and A8........See
Table 3
for Pump 2 Behavior settings
A9
.............In “ON” position, Filter cycles duration is 3 hours
..............In “OFF” position, Filter cycles duration is 2 hours
Table 2
Circ Pump
A5 A6
Behavior
OFF
OFF
Non-circ
OFF
ON
24-hour
ON
OFF
24-hour w/3˚F
ON
ON
Like Pump 1 low
Table 1
# of Hi-Speed
Pumps/Blower
Before Heat Disabled
A2 A3
OFF
OFF
0
ON
OFF
1
OFF
ON
2
ON
ON
Up to 4
Table 3
Pump 2
A7 A8
Behavior
OFF
OFF
No Pump 2
OFF
ON
1-Spd Pump 2
ON
OFF
2-Spd Pump 2
on
X-P332
ON
ON
1-Spd Pump 2
on
X-P332
Software Configured
To be filled is as individual system requires.
