Baker Hughes Panametrics oxy.IQ, Руководство пользователя

Страница: 35 / 56

oxy.IQ User’s Manual 27
Appendix A. Outline and Installation Drawings
Figure 13: Cable, IS (ref. dwg 704-1318, SH 2 of 2)
1
2.500±.125
X±1
B B
D
C
Blue & brown
primaries only
exit heat shrink
Hirose solder fixture
P/N HR30-6P-6S-T01
Plug insulator
body
Push/pul
locking
collarl
Spring
Back shell
Groove
sealing
bushing
Plastic
compression
fitting
6
7
8
Section B-B
1
2
3
4
5
6
.195±.020
Detail D
scale 2 : 1
.250±.020
Detail c
Scale 2 : 1
Wire color to location legend
1 = Brown, PVC, 26 AWG 7/34
2 = White, PVC, 26 AWG 7/34
3 = Blue, PVC, 26 AWG 7/34
4 = Black, PVC, 26 AWG 7/34
5 = Drain, PVC, 26 AWG 7/34
6 = Empty
Cable length
9
10
11
XX-cable length Part number extension
2 meters (6.56ft) 02
10 meters (32.81ft) 10
E S
P/N HR30-6P-T02
O R I H
Black shell
tightening collar
.100±.020
Notes
1. Cut cable to desired length according to length table shown.
2. Cut primaries & drain excluding brown & blue back to jacket as shown.
3. Strip & tin wires using lead free soder at end "b" , blue & brown, to a length of .250" as shown.
4. Strip & tin wires using lead free solder at end "a", 4 primaries & drain, to a length of .100"
as shown & tinned wire conductors not to exceed .020".
5. Insert insulator body over the solder termination fixture.
6. Insert pre soldered conductors, items 1-5, in the contact soldering pot and solder
(iron temperature 280°c 10°c) using lead free solder. In their respective numerical location
according to the color legend.
7. Inspect solder terminations on end "a" and trim any loose strands & eliminate any
solder
bridging.
8. Push components down and tighten back shell using hirose fixture shown.
To prevent accidental loosening of the back shell place a small amount of primer
(Loctite 7649) and adhesive (Loctite 271) in threads. Torque to 0.5 n-m.
End “A”
End “B ”