Bajaj pulsar DTS-i, Руководство по обслуживанию станции

Страница: 226 / 253

ELECTRICAL CHECKING
PROCEDURES
Pulsar 150/180 DTS-i
Service Station Manual
222
Dealer Development Center
Akurdi Pune
Battery DC Charging current : (Use fully charged
battery ensuring battery voltage = 12.5 0.3 V
before measuring)
+
To measure the DC charging current, set the meter
at 20ADC. Connect meter+ve lead to White/black
lead from RR Unit and meter -ve lead to battery
+ve lead.
Start the engine and set it at 4000 25 RPM.
Measure the DC charging current. The DC charging
current should be 0.7 A max stop the engine and
disconnect meter leads. Connect the RR unit and
battery. +
Meter
Range
Connection Specification
DC10A
Meter +ve
White/Black
terminal of
R/R
Meter -ve
Battery (+)
lead (White)
0.7 A max
at 4000+25
RPM
Note :
Connect multi meter in series with the circuit while
conducting above test.
DC Charging Voltage Measurement : (Use fully
charged battery while measuring)
To measure the DC voltage; set the meter at
20VDC range. Connect the meter +ve lead to white
from RR unit and meter -ve lead to ground. Start
the engine and set it at 4000 25 RPM. Measure
the voltage with and without headlight switch to the
ON position. Stop the engine disconnect the meter
leads.
+
Meter Range Specification at 4500 RPM
DC 20 Volt
14.3 to 14.7 V
Multimeter connected in
Parrallel with Battery for
checking DC charging
voltage
L/W
L/W
MAGNETO
R
W/B
L/W L/W
L/W L/W
W
W
W
W
W
CAPACITOR
REGULATOR
WITH CAPACITOR
W
FUSE
(10 Amps.)
STARTER RELAY
100A RATING
BATTERY
12V-9Ah
W
B
14.3
Multimeter connected
in Series with Battery
for checking DC
charging Current
L/W L/W
MAGNETO
R
W/B
L/W L/W
L/W L/W
W
W
W
W
W
CAPACITOR
REGULATOR
WITH CAPACITOR
W
FUSE
(10 Amps.)
STARTER RELAY
100A RATING
BATTERY
12V-9Ah
W
B
0.7