Baileigh Industrial BS-330M, Руководство оператора

Страница: 40 / 68

37
37
Down-Bow Dampener
The dampener (A) functions to produce a finer cut by
reducing the rate of bow descent as the blade nears
the table. The width of measurements of the blades
between inch size and mm size are slightly different.
This saw is equipped with inch size blade at the
factory. If the user did not get the inch type but instead
received a mm size blade, it is necessary to adjust the
dampener by turning the cap screw (A) clockwise
about 1-1/2 revolution, and also adjust the shut-off limit
switch. Otherwise, the saw bow will not automatically
rise up after completing the cut.
Thrust Roller Adjustment
1. Disconnect machine from the power source.
2. Loosen two hex socket cap screws (A).
3. Move guide seat (D) up or down until a clearance
of .003" to .005" (.08 - .13mm) between back of
blade and thrust roller is obtained.
4. Tighten two hex socket cap screws (A).
5. Repeat for other blade guide assembly.
6. Connect machine to the power source.
Guide Roller Adjustment
Note: Only bearing (A) is adjustable. Bearing
(B) is fixed.
1. Disconnect machine from the power source.
2. Loosen blade guides by loosening guide adjustment
screw (C).
3. Loosen locking screws (A) by using a hex wrench.
4. Adjust the eccentric bushings with a combination
wrench until the ball bearings are snug to the blade (A).
C
B
A
D
C