Baileigh Industrial BS-330M, Руководство оператора

Страница: 46 / 68

43
43
Lubrication
AII ball bearings are permanently lubricated and sealed. They require no further lubrication.
Replacing the Coolant
1. Disconnect the machine from the power source.
2. Remove the drain plug (A) with a hex wrench and
allow coolant to drain completely.
3. Remove the hex cap bolt (B) and move the pump unit
(D) away.
4. Clean the drain screens on the machine base and the
drains on the ends of the table.
a. Drain and wash out the dirt and debris from the
reservoir.
b. Vacuum out the chips and debris from the tank.
5. Replace the drain plug (A).
6. Add coolant to the highest level of the coolant sight gauge (C).
7. Replace the pump unit (D) and fasten the bolt (B).
Oils for Lubricating Coolant
Any 10:1 (water to coolant) solution will work; however we recommend Baileigh B-Cool 20:1
(water to coolant) biodegradable metal cutting fluid. It has excellent cooling and heat transfer
characteristics, is non-flammable, and extends tool and machine life. Each gallon of concentrate
makes 21 gallons of coolant.
Gear Case
The gear box lubricant should be changed after
the first 3 months of operation then changed
every year.
1. Disconnect machine from the power source.
2. Remove drain plug (A) and drain all of the
oil out of the gear box.
3. Replace the drain plug.
4. Remove oil filler plug (B) located
underneath the right blade wheel and fill the
gear box with 1-1/2 pints (.7L) of MOBIL
CYLINDER OIL # 600W or equivalent.
A
C
B
D
E
A
B