Baileigh Industrial BS-330M, Руководство оператора

Страница: 42 / 68

39
39
Changing Blades
1. Raise the saw arm approximately 6” (150mm). Press the emergency stop to hold the arm in
place.
2. Disconnect machine
from power source.
3. Loosen the thumb
knobs (A) to remove the
upper cover and open
the blade wheel covers
on each end of the bow.
4. Clean chips out of both
wheel housings.
5. Position the left guide
post inward to the stop
pin and then remove
the blade guard (C).
6. Remove wire brush assembly (D).
7. Release blade tension by turning blade tensioning hand wheel (E) counter-clockwise until
blade is free.
8. Remove old blade from both wheels and out of each blade guide.
9. Install new blade making sure teeth are
pointed downward in the proper cutting
direction. Match the arrow on the wheels and
the blade guides. If necessary, turn blade
inside out.
10. Position blade on band wheels and apply just enough tension to hold blade on wheels. Make
sure back of blade rests lightly against the wheel flange of both wheels. Twist blade slightly
to allow it to slip into guides.
WARNING:
Disconnect the machine from the power source before
making any adjustments or repairs! Failure to comply may result in serious injury!
CAUTION:
Even dull blades are sharp to the skin! Use extra caution
handling band saw blades!
A
A
A
E
B
D
C