Baileigh Industrial BS-330M, Руководство оператора

Страница: 45 / 68

42
42
LUBRICATION AND MAINTENANCE
The maintenance jobs are listed below, divided into daily, weekly, and monthly intervals. If these
operations are neglected, the result will be premature wear and poor performance.
Daily
•
Check daily for any unsafe conditions and fix immediately.
•
Check that all nuts and bolts are properly tightened.
•
Give general cleaning to the machine to remove accumulated shavings.
•
Clean the lubricating coolant drain hole to avoid excess fluid.
•
Top off the level of lubricating coolant.
•
Check blade for wear.
•
Raise the saw frame to top position and partial slacken blade to avoid useless yield stress.
•
Check functionality of the shields and emergency stops.
Weekly
•
Lubricate threaded components and sliding devices.
•
Apply rust inhibitive lubricant to all non-painted surfaces.
•
Thoroughly clean the machine to remove shavings, especially from the coolant tank.
•
Removal of pump from its housing, cleaning of the suction filter and suction zone.
•
Clean the filter of the pump suction head and the suction area.
•
Use compressed air to clean the blade guides (guide bearings and drain hole of the
lubricating and cooling tank).
•
Clean flywheel housings and the race of the flywheels.
Monthly
•
Check the tightness of the drive wheel screws.
•
Check that the blade guide bearings on the heads are in perfect running condition.
•
Check the tightness of the screws for the motor, pump, and accident protection guards.
WARNING:
Make sure the electrical disconnect is OFF before working on
the machine. Maintenance should be performed on a regular basis by qualified
personnel. Always follow proper safety precautions when working on or around any
machinery.