Baileigh Industrial BS-330M, Руководство оператора

Страница: 22 / 68

19
19
Material Stop
1. Unwrap the material stop parts.
2. Loosen the two set screws (A) on the hinge
assembly.
3. Insert the stop rod into the hinge assembly so that
the flat surface with the scale is up and the two
detents (B) align with the set screws.
4. When the set screws are aligned with the detents,
tighten both set screws (A).
5. Install the stop bracket onto the rod and tighten
the hand lever to hold in position.
The stop bracket may be pivoted into and out of the
cutting area as needed to be used for a stop or out of the way when not in use.
Laser Guide Mounting
1. Unwrap the laser assembly and disassembly the
wing nut and bolt to allow the extension arm to be
removed from the mounting bracket.
2. Locate the tapped mounting hole on the top of the
blade guide rail.
3. Position the spacer block over the hole with the
bracket on the top of the block with the slot opening
toward the back (inside) of the guide rail.
4. Keeping the spacer block as far forward as the
mounting hole will allow and the front edge of the
bracket even with the front edge of the spacer
block, install and tighten the mounting bolt.
5. Mount the thumb bolt so that the thumb head is
toward the front of the saw and the nut is on the
back of the bracket arm. Screw the thumb bolt
completely into the bracket. The thumb head will be
used to push against the laser body to assist in adjusting and the nut will lock the position
later in the setup.
6. Mount the extension arm onto the bracket so that it extends forward with the laser pointing
downward and resting against the thumb bolt head.
7. Lightly tighten the wing nut and bolt.
8. Plug the power cord into the top of the laser.
A
B