BADU Logic 2, Инструкция по установке и эксплуатации

Страница: 48 / 72

8
C.1.1 .
C.1.2.
Caution
C.1. Wall installation
Install the controller in dry areas only and under the ambient conditions de-
scribed under “B.1. Specifications”. Follow the instructions below:
1. Unscrew cover completely
2. Carefully pull upper part of housing
from lower part. Terminal clamps are
released during this process.
3. Set upper part of housing aside, being
sure not to touch the electric when doing
so.
4. Hold the lower part of the housing up
to the selected position and mark the 3
mounting holes. Make sure that the wall
surface is as even as possible so that the
housing does not become distorted when
it is screwed on.
5. Using a drill and size 6 bit, drill 3 holes
at the points marked on the wall and push
in the dowels.
6. Insert the upper screw and screw it in
slightly.
7. Fit the upper part of the housing and
insert the other two screws.
8. Align the housing and tighten the three
screws.
Installation
.