BADU Logic 2, Инструкция по установке и эксплуатации

Страница: 43 / 72

3
Safety instructions
By affixing the CE mark to the unit the manufacturer declares that the BADU
®
Logic 2 con-
forms to the EC low voltage directive 2006/95/EC and the EC electromagnetic compatibility
directive 2004/108/EC.
Conformity has been verified and the corresponding documentation and the EC declaration
of conformity are kept on file by the manufacturer.
A.1. EC declaration of conformity
These installation and operating instructions contain basic instructions and important
information regarding safety, installation, commissioning, maintenance and the optimal
use of the unit. Therefore these instructions must be read completely and understood
by the installation technician/specialist and by the system user before installation, com -
missioning and operation of the unit.
This device is an automatic, electronic temperature controller for domestic use and
similar uses. Only install the controller in a dry room and under ambient conditions
listed in “B.1. Specifications” on page 5.
The valid accident prevention regulations, the applicable standards and regulations
and the installation and operating instructions of the additional system components
must also be observed. The controller does not under any circumstances replace any
safety devices which are to be provided by the customer!
Installation, electrical connection, commissioning and maintenance of the unit may
only be carried out by specialists who have the appropriate training.
For the user: Make sure that the specialist gives you detailed information on the func -
tion and operation of the controller. Always keep these instructions in the vicinity of the
controller.
A.2. General instructions
Danger
Caution
A.3. Explanation of symbols
Failure to observe these instructions can result in danger to life from
electric voltage.
Danger
Failure to observe these instructions can result in serious damage to
health such as scalding or even life-threatening injuries.
Caution
Failure to observe these instructions can result in destruction of the unit
or the system or damage to the environment.
Information which is especially important for the function and optimal use
of the unit and the system.