Bad Boy 5' Cutter, Руководство по эксплуатации для владельца

Страница: 13 / 28

PAGE 13
OWNER SERVICE
The information in this section is written for operators who possess basic mechanical skills. If you need
help, your dealer has trained service technicians available. For your protection, read and follow the safety
information in this manual.
WARNING
■
Keep all persons away from operator control are while performing adjustments, service, or
maintenance.
CAUTION
■
If you do not understand any part of this manual and need assistance, see your dealer.
■
Always wear relatively tight and belted clothing to avoid getting caught in moving parts. Wear sturdy,
rough-soled work shoes and protective equipment for eyes, hair, hands, hearing and head.
BLOCKING METHOD
WARNING
■
Before performing any service or maintenance, disconnect driveline from tractor PTO.
■
Never go underneath equipment (lowered to the ground or raised) unless it is properly blocked
and secured. Never place any body part underneath equipment or between moveable parts even
when the engine has been turned off. Hydraulic system leak down, hydraulic system failures,
mechanical failures, or movement of control levers can cause equipment to drop or rotate
unexpectedly and cause severe injury or death. Follow Operator’s Manual instructions for working
underneath and blocking requirements or have work done by a qualified dealer.
To minimize the potential hazards of working underneath the cutter, follow these procedures.
1. Jack stands (4) with a load rating of at least 1000 lbs. are the only approved blocking device for this
cutter. Install a minimum of four jack stands under each corner of the cutter before working underneath
the unit. Do not position jack stands under wheels, axles, or wheel supports. Components can rotate
and cause the cutter to fall.
2. Consider (and check) the overall stability of the blocked unit before working underneath. The working
surface must be level and solid to properly support the jack stands while they are supporting the cutter.
Make sure the cutter is approximately level.