PAGE 18
■
Inspect the cutter and replace any worn or damaged parts. After an extended period of non-use,
any damage to the cutter may be overlooked, or forgotten, when the machine is again put into
service.
■
Sand down scratches and the edges of areas of missing paint and coat with Bad Boy touch-up
paint.
■
Replace any missing, damaged, or otherwise unreadable decals.
TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE
SOLUTION
Grass is cut lower in the center
of the path than at the edge.
Height of cutter is too low at
rear or front.
Adjust cutter height and
attitude so that cutter rear and
front are within ½˝ of same
height.
Streaking conditions in path.
Conditions too wet for mowing.
Blades unable to cut grass
pressed flat by tractor tires.
Dull Blades
Allow grass to dry before
mowing.
Slow ground speed of tractor
but keep PTO running at 540
RPM.
Sharpen or replace blades.
Material discharges from cutter
unevenly; material bunches
along path.
Material too high and dense.
Grass wet.
Rear of cutter too low, trapping
material under cutter.
Reduce ground speed
(maintaining 540 RPM tractor
PTO) or make two passes.
Raise cutter for the first pass;
then lower cutter to desired
height and cut perpendicular to
the first passes.
Allow grass to dry before
mowing.
Adjust cutter height and
attitude.
Cutter no longer cuts at all
(Shear bolt model).
Shear-bolt has sheared.
Install new shear-bolt.
Cutter will not cut all the time
(Slip-clutch model).
Slip-clutch excessively slipping. Adjust slip-clutch according
to instructions under ‘SLIP-
CLUTCH ADJUSTMENT’ section
of this manual.
Содержание 5' Cutter
Страница 1: ...OWNER S OPERATION PARTSMANUAL 10 28 2014...
Страница 19: ...PAGE 19 CUTTER ASSEMBLY AND PART LIST...
Страница 20: ...PAGE 20...
Страница 28: ...PAGE 28 102 Industrial Drive Batesville Arkansas 72501 870 698 0090...