Bad Boy 5' Cutter, Руководство по эксплуатации для владельца

Страница: 21 / 28

PAGE 21
ASSEMBLY INSTRUCTIONS
Note: Use cutter part list and accompanying illustration located in the previous section to reference item
numbers indicated in the assembly instructions. Item numbers are in parenthesis. Partial or full assembly of
the cutter may have been performed prior to purchase.
1. Attach Front Hitch Braces (4) to the hitch points located at the front of 5´ Cutter Deck Assembly (1)
with Category 1 Lift Pins (25). The braces should be on the inside of the hitch points; the lift pins on
the outside. Do not tighten.
2. Insert 5/8˝ x 6˝ Hex Bolt (12) through the following parts in the order given: 5/8˝ Flat Washer (19); Front
Hitch Brace (4); Middle Brace (3); Hinge Spacer (6) {At this point, slide Hinge Spacer through the larger
holes of Hinge Bracket (5)}; Middle Brace (3); Front Hitch Brace (4); 5/8˝ Flat Washer (19). Secure with
5/8˝ Nylock Nut (16). Do not tighten.
3. Insert 5/8˝ x 2-1/2˝ Hex Bolt (9) through the following parts in the order given: from the outside-in, the
rearward, left 5/8˝ hole in the ‘H’ frame of 5˝ Cutter Deck Assembly (1); 5/8˝ ID 1/4˝ Thick Nylon Spacer
(22); 5/8˝ hole in Rear A-Arm Assembly (2); Middle Brace (3). Secure with 5/8˝ Nylock Nut (16). Do not
tighten. Repeat step #3 for the right side.
4. Attach Height Adjustable Plate (7) by way of the two 1/2˝ holes at the rear of 5´ Cutter Deck Assembly
(1) using two 1/2˝ x 1-1/4˝ Hex Bolts (10) and two 1/2˝ Nylock Nuts (17). The bolts should pass
through the flat portion of Height Adjustable Plate, 1/2˝ holes of 5´ Cutter Deck Assembly, and secured
underneath the deck with the 1/2˝ Nylock Nuts. The curvature of the Height Adjustable Plate should
‘point’ forward with respect to the 5´ Cutter Deck Assembly. The Height Adjustable Plate should also
be forward of the cross brace on Rear A-Arm Assembly (2). Tighten to 70 ft-lbs as indicated in the
Fastener Torque Chart.
5. Attach Rear A-Arm Assembly (2) to Height Adjustable Plate (7) using two 1/2˝ x 1-1/4˝ Hex Bolts (10)
and two 1/2˝ Nylock Nuts (17). The bolts should pass through the two holes on the cross brace of
Rear A-Arm Assembly, the top two holes on the curved section of Height Adjustable Plate, and secured
with the two 1/2˝ Nylock Nuts. {When cutter is placed into service, any of the four hole pairs on
Height Adjustable Plate may be utilized for cut height selection.} Tighten to 70 ft-lbs as indicated in the
Fastener Torque Chart.