Bad Boy 5' Cutter, Руководство по эксплуатации для владельца

Страница: 9 / 28

PAGE 9
ATTACH CUTTER TO TRACTOR
CAUTION
■
Make sure driveline will not bottom out at the shortest length and that it has at least 1/3 overlap at
its longest length.
■
Select a top link mounting pin that will allow floating link to swing freely through the cutter
A-frame bars.
1. Attach tractor 3-point lift arms to the cutter hitch pins and secure.
2. Attach tractor top link to cutter clevis. Select a top link mounting pin that will allow floating link to swing
freely through the cutter A-frame bars. NOTE: You will need to adjust the top link; refer to ‘Top Link
Adjustment’ in the next section.
3. Adjust the tractor lower 3-point arm anti-sway devices to prevent cutter from swinging side-to-side during
transport.
4.
TOP LINK ADJUSTMENT
1. Attach tractor top link to lowest hole provided in the tractor’s top link bracket.
2. Attach rear portion of tractor top link to the hole on the cutter floating link. Select a top link mounting pin
that will allow the floating link to swing freely through the cutter A-frame bars.
3. Raise cutter to transport position and adjust tractor top link until cutter is level in the raised position.
4. If you cannot level the cutter using the lowest hole in the tractor’s top link bracket, move top link to the
next hole and level the cutter.
DRIVELINE INSTALLATION (TRACTOR PTO)
WARNING
Make sure spring-activated locking pin slides freely and is seated firmly in tractor PTO spline groove.
INSTALLATION
Push spring-activated locking pin and at the same time, push the driveline onto tractor PTO shaft until the
locking pin is able to engage the shaft.
REMOVAL
Hold driveline securely in position, push the spring-activated locking pin and slide driveline off tractor PTO
shaft.