Baby Lock Kinetic Frame, Руководство по сборке

Страница: 23 / 28

Baby Lock Kinetic Frame Assembly Instructions 23
11-7: Repeat steps 11-5 and 11-6 to add a
second pole end to the other open end of the
pole assembly just built and one pole end to
each of the remaining 3 pole assemblies
(Fig. 11-5). Repeat the process and set the
two poles with two pole ends aside as the
batting storage pole and the idler pole.
Short-Bolt Ratchet-Wheel Assembly
11-8: Check the short-bolt ratchet wheel
assembly to ensure that it matches Fig. 11-6.
11-9: Loosen the nut at the end of the short-
bolt ratchet wheel assembly until it nearly
reaches the end of the bolt.
11-10: Holding onto the outside of the pole
end, push the nut end of the bolt towards the
opposite end of the assembly until the inside
pole end short-bolt wedge slides out (in similar
fashion to Step 11-3). This makes the outside
diameter of the outside pole end smaller and
ready to be inserted into the end of the pole
assembly.
Long-Bolt Ratchet-Wheel Assembly
11-12: Add the hand wheel assembly and
hand wheel insert as shown in Fig. 11-7,
aligning the three tabs on the hand wheel insert
with the three notches on the outside pole end.
If the three tabs are not properly aligned, the
hand wheel will spin freely, independent of
the pole.
Outside Pole End
Inside Pole End Short Bolt Wedge
Short Bolt Wedge
Ratchet Wheel
Large Washer
V Bearing
Small Washer
Hex Nut
Fig. 11-6
Short-bolt ratchet assembly comes
pre-assembled. Exploded diagram is
for reference only.
Fig. 11-7
Step 11
Pole End Assembly (continued)
Long Bolt Ratchet
Wheel and Hand
Wheel Assembly
Ratchet Wheel
Hand Wheel
Small Washer
Lock Nut
Large Washer
V Bearing
Outside Pole End
Hand Wheel
Insert
Tab
Hole
Long bolt ratchet wheel assembly comes pre-assembled
without hand wheel and hand wheel insert. Exploded
diagram is included for reference.
Fig. 10-1
Fig. 9-6
Fig. 2-1
Fig. 1-1
Batting Storage & Idler Pole
Fig. 11-5
Fig. 10-1
Fig. 9-6
Fig. 2-1
Fig. 1-1
X2